Baumfolder 714: Friction-Operations Manual - Manual (Page 5)

PAGE 5 TP10449
Figure 4.1-1
WARNING
Do not plug the power cord into an AC outlet until
the 714 Friction is fully assembled, adjusted and ready to
use. Unplug the 714 Friction any time disassembly is
required.
4.0 ASSEMBLY
4.1 Main Unit
To assemble the 714 Friction unit, first remove the
four bolts holding it to the skid. Place the folder on the
stand (See Figure 4.1-1).
4.2 Slitter Shaft Installation
To install the slitter shaft, hold it with the grooves in
the boxings down. Be sure the slitter shafts are free
turning.
Insert the slitter shaft and seat the grooves in the
boxings on the lower locating pins in the side frames. (See
Figure 4.2-1)
Check for proper gear engagement between the upper
slitter shaft gear and the 19-tooth frame idler gear by
turning the handwheel.
Slitter Shaft Assembly
4.3 Delivery Table
To install the delivery table, loosen the knobs on
either side of the stacker table. Drop the tray over the
knobs and retighten.
Figure
4.3-1
4.4 Feed Table Assembly Installation
Insert the feed table with the feed wheel toward the
fold rolls. Slide the paper feed table over both sets of
locating pins.
(See Figure 4.4-1)
Figure 4.4-1
Figure
4.2-1