Baumfolder 714: Friction-Operations Manual - Manual (Page 6)

TP10449 PAGE 6
The first notch in the front part of the feed table
should rest on the pins. Then drop the rear notch down on
the upper dowel pins.
Rotate the handwheel to check that the gears are
properly meshed.
4.5 Fold Plate Installation
WARNING
Unplug the AC power cord when installing or
removing fold plates.
The fold plates are marked #1 and #2 and are not
interchangeable. The #1 fold plate is installed in the top
position, the #2 fold plate in the lower position.
Each fold plate has an open end which faces toward
the fold rolls.
To install the fold plates, pivot the fold plate hold-
downs out of the way and slide the fold plate in position
so that the slots in the leading edge of the fold plate
engage the two locating pins in the side frames.
(See
Figure 4.5-1)
The center notches should seat on the second set of
locating pins. Pivot the fold plate hold-downs back into
position to secure the fold plates.
Turn the handwheel to be sure that the fold plates are
properly installed and not rubbing on the fold rolls.
#1 Fold Pan
#2 Fold Pan
Hold-
down
Figure 4.5-1