Baumfolder Rebuilding a small, older folder - Manual (Page 2)

Section 1 - How to Rebuild a Baumfolder..... continued
9. It is not necessary to remove the register table to change the fold rollers, but I recommend
it to allow better access when removing rollers and later when setting the eccentrics and
fold plate setting on # 2 and # 4 plate and rolls.
10. To remove register table:
A) Remove paper hold downs
B) Remove tuck in shoes.
C) Remove marbles from marble guide.
D) Remove marble guide.
E) Remove side guide. Slide register belt under marble guide
over to get to the flat head screws that fastens the side guide.
F) Remove tape tighten assembly. (under register table) loosen
2 bolts on each end and slide assembly toward operator side
from above the belts and below the register table.
G) Remove taper plate between feeder and register tapes (a flat head screw on each
end.)
H) Lift up on the large tape roll, (by feeder), on the non-operator side of the folder
and slide it toward you to remove it.
I) Have two people, one on each side of the register to hold the register while
removing the four bolts that fastens it to the frame. Then lower the end toward the
feeder down and forward and lift up the opposite end until the register clears the
Baumsets/ roller adjustment stems. Then lift the register to a safe location where it
will not be damaged.
J) To replace register when finished, reverse procedure I through A.
11. Remove slitter shafts.
12. Remove all tension block bolts. Ten (five on
each side) on a three or four plate folder, six
(three on each side on a two plate folder.
13. If the folder has oil lines, remove oil lines from
the roll boxing and main drive roll.
Remove the clip that fastens the oil lines to the
frame on the operator side just above the number
one roller.
14. Remove the right and left roll boxing eccentric
from the number one fold roller. (Note: these
eccentric bolts are usually fine thread. Most of
the other bolts are course thread.) Lift the
number one roll up and out of the folder.
15. Continue step number 14 on the #2, then #4,
then #5, then#3 rollers in that order. Rollers
number 5 and 3 should come under the roll
bank and toward the delivery end of the roll bank to remove.
16.
Remove hand wheel on operator side of the folder. If the hand wheel is not free of the
fold rollers, it should be left off or replaced by one that engaged when you want to turn
the folder by hand.
Section 1 - Page 2