Baumfolder Rebuilding a 200 – 700 series folder - Manual

* This manual to be used with 200 and 700 Series Baumfolder Folding Equipment
· Section 1: How to Rebuild a Baumfolder
· Section 2: Setting fold plates and deflectors
· Section 3: Calibration of Zero Baumset
· Section 4: Calibrating the Caliper
·
Appendix A
: Suggested Special Tools List
·
Appendix B
: Roll Pan and Deflector Settings
-
For Cast fold pans
·
Appendix C
: Roll Pan and Deflector Settings
-
For Fabricated fold pans
·
Appendix D
: Worksheet
·
Parts Order form
Before working on the folder, DISCONNECT ALL ELECTRICAL POWER SUPPLY TO THE
FOLDER to prevent the accidental start of the folder. Check to be sure you have the
correct tools to complete the job.
For reasons of safety, long hair must be tied back or otherwise secured, garments must be
close fitting and no jewelry, such as rings or necklaces, may be worn while adjusting or
setting up equipment. Injury may result from being caught up in the machinery or jewelry
catching in moving parts.
For more information or to order parts phone Baum at 1-800-543-6107
Ó 2002 Baumfolder Corporation
All Rights Reserved