Baumfolder Rebuilding a 200 – 700 series folder User Manual
Page 14
Section 4:
To Calibrate Caliper
Turn Caliper Adj. knob counter clockwise and push down until Throw off wheel contact the
Feed Roll. Loosen set screw ( A ) – insert a Dime (10¢ piece) between Caliper squaring
block and Throw off wheel setting lever. Make sure Draw roll latch is latched on to caliper
reset pin. Apply light pressure down on Caliper adj. knob and tighten set screw ( A ).
Remove dime and adjust caliper by turning Caliper adjust knob clockwise until one (1) sheet
of material you are running moves free between Throw off wheel and the feed roll but not two
(2) sheets.
The set screw with the ½” nut on the left side of the Caliper squaring block should be set so
the block slides up and down free but doesn’t rock back and forth.
** End of Section 4 **
Page 14 of 19
Ó 2002 Baumfolder Corporation Phone 1-800-543-6107
All Rights Reserved