Baumfolder 714XLT: Set up - Manual (Page 6)

Appendix A:
Squaring Side Guides
on the 714XLT folders
If the fold is not folding straight or wrinkling:
Square the guide with the fold rollers.
1. Remove the number 1 fold plate (top fold plate).
2. Take an 11 x 17 sheet of paper that is cut square and lay on feed table against one of the side
guides.
3. Hand feed the sheet into the folder and watch the sheet come out of the first set of rolls. Watch
the sheet to see if it comes out square, or if one corner comes out before the other. If one corner
comes out before the other you know you are not feeding square.
4. Referencing the diagram above, loosen the rear locking screws on the back of the side guide,
then push in the micro-adj. knob and rotate the back of the side guide in the direction that the
back of the paper needs to move to square the side guide. Once you have moved the side guide
retighten the rear locking screws.
5. Repeat step 3 to see if the paper is now coming out square. If not repeat step 4 until side guide is
square.
6. When you get the side guide square then loosen the collar and rotate it until the micro-adj. knob
falls back on to it then retighten the collar.
7. Then align the other side guide to the first side guide using the square sheet of paper.
** End of Appendix A **
Baumfolder Corporation P.O. Box 728 1660 Campbell Rd, Sidney, Ohio USA 45365 Copyright © 2002
Phone 1-800-543-6107 or 1-937-492-1281 Fax 1-937-492-7280 email: [email protected]