Bendix Commercial Vehicle Systems TABS-6 ADVANCED MC SD SHEET - Manual (Page 15)

15
Diagnostic Trouble Codes
(DTCs)
(continued)
1st
Digit
2nd
Digit
Diagnostic Code
Description
Possible Causes / Repair Information
J1587
(SID/
FMI)
J1939
(SPN/
FMI)
8 2
Lateral Acceleration
Sensor - Signal Out
Of Range
• Before troubleshooting, verify that the trailer has been parked on
level ground.
• Verify that the TABS‑6 Adv MC module has been mounted as per the
Installation Guidelines.
• Perform a Lateral Acceleration Sensor (installation angle) Component
Test using the Bendix ® ACom ® diagnostic software (version 6.1 or
higher), and verify that the roll angle of the TABS‑6 Adv MC module
is within ±5° as measured from a flat horizontal plane.
• After repairs — or if no issues are found — clear the diagnostic code.
• If the diagnostic code persists, contact your local Bendix
representative before replacing the TABS‑6 Adv MC module.
099/14 1809/14
8 3
Internal Lateral
Acceleration Sensor
- Offset Error
• Before troubleshooting, verify that the trailer has been parked on
level ground.
• Verify that the TABS‑6 Adv MC module has been mounted as per the
Installation Guidelines.
• Perform a Lateral Acceleration Sensor (installation angle) Component
Test using the Bendix ® ACom ® diagnostic software (version 6.1 or
higher).
 Verify the roll angle of the TABS-6 Adv MC module is within ±5° as
measured from a flat horizontal plane.
 If the roll angle is out of tolerance, clear the diagnostic code and
test drive the vehicle.
• After repairs — or if no issues are found — clear the diagnostic code.
• If the diagnostic code persists, contact your local Bendix
representative before replacing the TABS‑6 Adv MC module.
099/02 1809/02
8 4
Lateral Acceleration
Sensor ‑ Sensor
Signal Not Found
• Verify that the TABS‑6 Adv MC module has been mounted as per the
Installation Guidelines:
 TABS-6 Adv MC module mounted either in 0° or 180° orientation.
• If the ECU has been configured for an external lateral acceleration
sensor:
 Check for corroded/damaged wiring or connectors between the
ECU and the external lateral acceleration sensor.
 Verify correct wiring between the ECU and the external lateral
acceleration sensor.
099/14 1809/14
8 5
External Lateral
Acceleration Sensor
Signal Not Available
• Check for corroded/damaged wiring or connectors between the ECU
and the external lateral acceleration sensor.
• Verify correct wiring between the ECU and the external lateral
acceleration sensor.
• After repairs — or if no issues are found — clear the diagnostic code.
• If the diagnostic code persists, contact your local Bendix
representative before replacing the Bendix ® TABS‑6 ™ Adv MC
module.
099/14 1809/14