Bendix Commercial Vehicle Systems WINGMAN ADVANCED SD - Manual (Page 37)

37
Appendix B
Driver Interface Unit: Displays & Alerts
When the initialization sequence is complete, the following screen is displayed for approximately 3 seconds
to indicate the features available to the driver.
(No LEDs
Illuminated)
Bendix
Wingman ACB
Wingman Adv.
Next, the DIU will enter normal operation. Under normal operation, the screen is:
(No LEDs
Illuminated)
If the Bendix
® Wingman ® Advanced ™
goes into self-test mode, the DIU may briefl y display the “Bendix Self-
Test” screen. Also, the audible distance alerts will activate, followed by a screen indicating that the self-test
has run. Below left is the screen that will be briefl y displayed if the self-test runs and passes. Below right is
the screen that will be briefl y displayed if the self-test runs and fails. If the self-test fails, a diagnostic trouble
code (DTC) will be set. The driver should turn off the vehicle, wait 15 seconds and then turn it back on again.
If the problem persists, a qualifi ed technician will be necessary for troubleshooting. See the “Power-Up Self-
Test” in this service data sheet Section 3.1: Troubleshooting Basics for further information.
Bendix
Self Test
Bendix
Self Test Failed
Single Yellow LED
Illuminated
(Followed
by a Single
Orange
LED
Illuminated)
B1.2 Menu Operation
Pressing the “OK” button at any time will enter the “Menu Operation Mode”. The following selections will
appear in a scrollable window. Some items may not appear if the feature is not confi gured or not allowed as
shown below.
• Volume
• Dist. Setting (Distance Setting)
• Dist. Units (Distance Units)
• US/Metric
• Brightness
• System Status
• Diag. Display (Diagnostic Display)
• Demo (Demonstration. Note: Demo is available only when vehicle is not moving)
The desired menu item is highlighted using the up (
) or down ( ) arrow buttons and selected
with the “OK” button. The following sections describe each menu item.
Appendix B