Bendix Commercial Vehicle Systems GEN 5 ABS - Manual (Page 16)

16
Test Equipment
Bendix recommends the use of the following products to
troubleshoot the ABS system:
• A multimeter or digital volt-ohmmeter (DVOM).
• Eaton ServiceRanger PC software or an MPSI ProLink ®
hand-held tester.
Multimeter
A multimeter can be used to check:
• Speed sensor circuit resistance.
• PMV and ATC valve solenoid resistances.
• ABS power circuit voltages.
• Engine data link voltages.
• Retarder control relay.
• Wiring harness diagnostic trouble codes.
ServiceRanger PC Software
ServiceRanger PC software can be used to read and clear
error codes and obtain a short description of failures. The
software can initiate test sequences for controller outputs
and can also read system data such as voltage at the
ECU, wheel speeds and cutout speeds.
CAUTION: Eaton ServiceRanger PC software can activate
output tests for all output devices. Since these tests can
affect operation of the vehicle braking system, the ECU
incorporates special safety protection. One axle must
show zero speed or the test will be halted.
FIGURE 19 - ServiceRanger Menus & Hardware Setup
1. Monitor Data
Wheel Speeds
Cut-Out Speeds
Input Voltages
Switch States 2. Retrieve Trouble Codes
Retrieve Trouble Codes
Clear Trouble Codes 3. Adv. Prod. Functions
Test Valves
Test Lights
Test Retarder Control 4. Product Downloads
Read ECU Configuration
Configure ECU
Disable ATC
ServiceRanger Main Menu Options
1. Monitor Data
2. Retrieve Diagnostic Trouble Codes
3. Advanced Product Functions
4. Product Downloads
P C IN
T E R FA
C E
To Diagnostic
Connector
Deutsch HD-10
Connector
Serial Communicator
Interface
Laptop PC
ServiceRanger
Software CD