Bennett Marine Premier Line Systems - Manual (Page 10)

• Use a small bead of sealant around the perimeter of the display to seal.
• Using the 4 nylon thumb-nuts, secure the display. (Do not over-tighten.)
NOTE: IF YOU HAVE A SINGLE STATION SYSTEM, jUMP TO STEP 13.
Step 8: Mounting the EIC Bridge Box (#4 on System Schematic)
• Mount the EIC Bridge Box within the length of the thick gray EIC Wire Harness (Part# EIC301, #3 on System Schematic) that will plug
into the Lower Helm EIC Display.
Step 9: Connecting the EIC Wire Harness (Blue) to the EIC Bridge Box
• Plug the EIC Wire Harness (Part# EIC201, #5 on System Schematic) into the EIC Relay Module (#6 on System Schematic) .
• Plug the other end of the Blue EIC Wire Harness into ANY of the three connectors on the Bridge Box.
• The cable must be properly strain relieved at both ends to support the weight of the blue cable at the Bridge Box.
Step 10: Connecting the Upper Helm EIC Display (secondary) to the EIC Bridge Box
• Plug the thin gray EIC Bridge Wire Harness (Part# EIC801, #2 on System Schematic) into the back of the Upper Helm EIC Display.
• Plug the EIC Bridge Wire Harness into ANY of the three connectors on the Bridge Box.
• The cable must be properly strain relieved at both ends to support the weight of the cable at the Bridge Box.
Step 11: Connecting the Lower Helm EIC Display (primary) to the EIC Bridge Box
• Plug the thick gray EIC Wire Harness (Part# EIC301, #3 on System Schematic) into the back of the Lower Helm EIC Display.
• Plug the EIC Wire Harness into the remaining connector on the Bridge Box.
• The cable must be properly strain relieved at both ends to support the weight of the cable at the Bridge Box.
Step 12: Cutting the Wiring for Upper Helm EIC Display (secondary)
• DO NOT connect the orange and purple wires at the Upper Helm EIC Display. Cut the orange and purple wires off the display.
FOR SINGLE STATION SYSTEM ONLY
Step 13: Running the EIC Wire Harness
(Part# EIC201, #5 on System Schematic)
• Plug the EIC Wire Harness (Blue Cable) into the back of the EIC Display and run to the location of the EIC Relay Module.
• Plug the Blue EIC Wire Harness into the EIC Relay Module.
• The cable must be properly strain relieved at both ends to support the weight of the blue cable.
FOR BOTH DUAL AND SINGLE STATION SYSTEMS
Step 14: Connecting the Wiring for the Lower Helm EIC Display (primary)
• Connect the Purple wire containing the inline 1.5 amp fuse to the ignition switch or any 24 or 12 volt circuit that turns on with the
ignition.
This wire is used to initiate Auto Tab Retraction when the ignition is switched to the off position.
• Connect the Orange wire containing the inline 1.5 amp fuse to a source that supplies power to the boat’s electronics and/or gauges.
This wire senses the power and shuts off the display when the helm power is shut off.
Step 15: Connecting the Power and Ground on the EIC Power Cables (#7 on System Schematic) to the EIC Relay Module
• Attach the black wire to battery ground. Attach the orange wire with inline fuse to the same battery positive power source.
10
GO TO STEP 14.
GO TO STEP 14.