Bennett Marine Premier Line Systems - Manual (Page 9)

SST Actuators with Sensor Wires should already be mounted per instructions on pages
4-6.
Step 1: Mounting the EIC Relay Module
(#6 on System Schematic on Page 8)
• Mount the EIC Relay Module in a dry location centrally located between the two
Dual Acting Hydraulic Power Units (DAHPUs).
Step 2: Mounting the Port and Starboard Dual Acting Relay Modules
(#8 and #9 on System Schematic)
• Mount the Port Dual Acting Relay Module (Red Collar on the Connector) near the port DAHPU.
• Mount the Starboard Dual Acting Relay Module (Green Collar on the Connector) near the
starboard DAHPU.
• Attach the black wires to battery ground. Attach the orange wires with inline fuse
to the same battery positive power source. The orange wires will supply power to
the DAHPUs — make sure that the power source is rated for 10 amps (24V) or 20 amps (12V).
Step 3: Connecting the Y-Harness (#10 on System Schematic)
• Connect the “Y-Harness” to the longer of the two cables on the EIC Relay Module.
Note: The shorter cable coming out of the EIC Relay Module is for the optional
Auto Tab Control (AC3000). If no Auto Tab Control is installed this cable is not used.
• Connect the Y-Harness plug with the Red Collar to the Port Dual Acting Relay Module plug (red to red).
• Connect Y-Harness plug with the Green Collar to the Starboard Dual Acting Relay Module plug (green to green).
Step 4: Connecting the DAHPU (#11 on System Schematic) Wire Harnesses to the Port and Starboard Dual Acting Relay Modules
• Connect the Port DAHPU Wire Harness to the Port Dual Acting Relay Module.
• Connect the Starboard DAHPU Wire Harness to the Starboard Dual Acting Relay Module.
Step 5: Connecting the DAHPU ground wire
• Run the black ground wire from the back of each Dual Acting Hydraulic Power Unit (#11 on System Schematic) to
the vessel’s 24V or 12V battery ground system.
• DO NOT connect to EIC Relay Module grounding stud. (See Figure 9 above)
Step 6: Connecting the Sensor Wires
• Plug the Green Sensor Wire into the Starboard Sensor Wire Connector (green collar) on the EIC Relay Module (#6 on System Schematic) .
• Plug the Red Sensor Wire into the Port Sensor Wire Connector (red collar) on the EIC Relay Module (#6 on System Schematic) .
Step 7: Mounting the EIC Display at the Helm
(#1 on System Schematic)
Follow these instructions for both the Lower Helm and Upper Helm EIC Displays
• Using the enclosed paper EIC Display Template, mark the location for your EIC Display and
locate the centers of the holes on the template.
• Use a 51mm (2") hole-saw to cut the center hole and 5mm (3/16") drill for the four
mounting stud holes.
Installation Instructions for Electronic Indicator Control (EIC)
Dual Station SST System
IMPORTANT: MAKE ALL ELECTRICAL CONNECTIONS WITH POWER OFF
9
EIC Relay Module
Figure 9
Spare: For
Optional Auto
Tab Control
Starboard Sensor
Wire Connector
Port Sensor
Wire Connector
Power Cables
Connects to
Y-Harness
Connects to
EIC Display
Grounding Stud
DO NOT CONNECT TO DAHPUs