Bird Technologies 8640B Series - Manual (Page 37)

Bird 8640 Series Moduload RF Load Resistor
26
14. Run the pump for five minutes and check for leaks before applying
RF power.
Conductor
Replacement
1. Use a
3
⁄
16
allen wrench to remove the cap screws [16] from the RF
connector.
2. Remove the outer conductor assembly [12].
 NOTE: If only the outer conductor needs replaced, install it now
and screw it into place.
3. Remove the center conductor assembly [11] by pulling it carefully
out of the load housing. Make sure the resistor [1] and inner flow
tube [9] do not come out with the center conductor.
4. Insert the new center conductor assembly into load housing. Make
sure the resistor fitting makes a snug fit with the resistor.
5. Replace the outer conductor and screw it into place.