Bird Technologies VPM3 - Manual (Page 28)

20
Units
Power -
Toggles the power measurement between Watts and Decibels.
Match -
Allows selection of match measurement units.
Note:
This is dependent on the sensor attached.
Start Acquisition
Starts a trace for the selected session.
Stop Acquisition
Holds a trace until a started again.
Max Hold
Holds and displays the highest trace data points.
Zero
Performs a zero calibraion on the selected sensor. See “Zeroing a Sensor” on
page 32.
Log
Enable Data Logging
Starts monitoring the selected Measurement type. See “Logging” on page 30.
Logging Settings
See “Logging” on page 30.
Figure 15 VPM, Logging Settings
View
Control Panel
When selected, it will display the control buttons.
Playback Controls
When selected, it will display the playback controls.