Bretford CDM-8500 - Manual (Page 9)

CHARGING THE BA CHARGING THE BA TTER TTER Y Y
NOTE: Charging time applies only when your phone is
turned off. Charging time may vary if your phone
is turned on.
NOTE: These times are for a new battery. Talk and
standby time may decrease over time.
BATTERY TALK & STANDBY TIMES
Battery Type
BTR-
(900mAh)
minutes
BTE-
(900mAh)
minutes Charging Time
Status
Type
PCS CDMA AMPS
157 150 103
113 103 25
Talk (min)
Standby (hrs)
BATTERY CHARGING TIME
Chapter 1 - Page 15
CHARGING THE BA CHARGING THE BA TTER TTER Y Y
NOTE: 1. It is more efficient to charge the battery with
the handset off.
2. The battery must be connected to the phone in
order to charge.
3. If the LED flickers while charging, the battery
contacts may need cleaning.
4. Once fully charged, the LED may change from
red to green. This does not indicate a
problem with the battery.
5. Battery operating time gradually decreases over
time.
6. If the battery fails to perform normally, you may
need to replace the battery.
Page 14 - Chapter 1
POWER CONNECTION
Connect the charger to a standard 110V AC outlet. The
battery can be charged alone, or when attached to the
phone.
NOTE: 1. The battery is not charged at the time of
purchase.
2. Fully charge the battery before use.
● Red indicates charging is in progress.
● Green indicates charging is complete.
CHARGING THE BATTERY
The battery can only be charged when attached to the phone.
The LED will indicate charging status.
50C-Bell south 10/4 2002.10.4 6:47 PM Page 16