Brother HL-4200CN - Manual (Page 31)

PRINTER SYSTEM SETTINGS 1 - 8
Setting Protocols
When the printer is shipped from the factory, all protocols except FTP are active by default. Normally
if you are connecting a new printer to a network for the first time, you will not need to perform the
operations described in this section. If you need to change any of the default protocol settings, follow
the steps outlined in this section.
The printer settings are completed. Proceed to Confirming Settings on page 1-9.
Supported Protocols:
■ For TCP/IP(LPD) → LPD protocol
■ For port 9100 → Port9100 protocol
■ For IPP → IPP protocol
■ For NetBIOS (transport protocol: TCP/IP) → NetBIOS TCP/IP protocol
■ For NetBIOS (transport protocol: NetBEUI) → NetBIOS NetBEUI protocol
■ For NetWare → NetWare protocol
■ For AppleTalk → AppleTalk protocol
To learn how to operate the control panel, see Basic Menu Operation on page 4-4.
Changing Protocol Settings
Ready to Print (The print screen. The printer is ready to print.)
↓
1
Press the Menu button. The menu screen will appear.
Menu
1:System
(The menu screen)
↓
2
Press the button 4 times.
Menu
5:Network
↓
3
Press the Form Feed/Set or button once.
5:Network
Ethernet
↓
4
Press the button 3 times.
5:Network
Protocol
↓ 5
Press the Form Feed/Set or button once.
Continued