Brother HL-4200CN - Manual (Page 86)

4 - 13 CONTROL PANEL
Network
Use Network to make or change network settings.
■ You cannot change the Network setting while the printer is processing print data.
■ You must restart the printer for settings to take effect. After programming settings, be sure to
restart the printer.
Ethernet
Use Ethernet to set Ethernet communication speed and mode.
■ Auto (default)
10Base-T Half, 10Base-T Full, 100Base-TX Half, or 100Base-TX Full is selected automatically.
■ 10Base/Half
■ 10Base/Full
■ 100Base/Half
■ 100Base/Full
TCP/IP
Use TCP/IP to make TCP/IP settings. This menu contains the following:
■ Setup IP Address
Select how to obtain an IP address. Parameters are as follows:
DHCP (default)
The IP address is obtained from a DHCP server on the network.
Panel
Use this to set the IP address from the control panel.
■ IP Address
Use this to set the IP address.
[aaa.bbb.ccc.ddd]
Set aaa, bbb, ccc, and ddd between 0 and 255.
You cannot use the following:
■ These settings are ignored when you select DHCP in Setup IP Address. To enable the settings,
select 'Panel' in 'Setup IP Address'.
■ Specifying the wrong IP address can affect the entire network. Before setting an IP address, call your
system administrator.
224.xxx.xxx.xxx or 255.xxx.xxx.xxx
127.xxx.xxx.xxx