Blizzard Lighting CSI Xtreme The Puck (Rev B) - Manual (Page 14)

Page 14
The Puck CSI Xtreme User Manual Rev. B Copyright (c) 2014 Blizzard Lighting, LLC
DMX Mode
Allows the unit to be controlled by any universal DMX controller.
Set the DMX Starting Address
1. To set the DMX address of the fixture, use the <MENU> button to navigate to
Addr, then press <ENTER>.
2. Then use the <UP/DOWN> buttons to choose the starting DMX address
within the range of 000-512.
3. Press the <ENTER> button to confirm.
Set the DMX Channel Mode
1. To set the DMX channel mode of the fixture, use the <MENU> button to
navigate to ChNd, then press <ENTER>.
2. Then use the <UP/DOWN> buttons to highlight 7CH or 4CH.
3. Press the <ENTER> button to confirm.
Master/Slave Modes
Allows you to link up to 32 units together without a controller.
1. To set the unit to act as either a master or slave, use the <MENU> button to
navigate to SLNd, then press <ENTER>.
2. Use the <UP/DOWN> buttons to highlight NASt (master) or SLAu (slave).
3. Press the <ENTER> button to confirm.
*There can be only one master fixture in the DMX chain. The first fixture should
be set as the master, while the others set as slave units. It may be necessary to
use a terminator at the last fixture.
Sound Active, Pixel Groups, Auto, & Fade Mode:
Display static pixel groups individually or combined in sound active, auto or fade modes.
Sound Active Mode
1. Use the <MENU> button to navigate to ShNd then press <ENTER>.
2. Then use the <UP/DOWN> buttons to display SoUn (the display will flash).
3. Do not press any buttons. You will enter sound active mode in 15 seconds.
Static Pixel Groups
1. Use the <MENU> button to navigate to ShNd then press <ENTER>.
2. Then use the <UP/DOWN> buttons to display CoLo then press <ENTER>.
3. Press the <UP/DOWN> buttons to display Co 1 - Co15.
4. Press the <ENTER> button, then <ENTER> again to save.
Auto Mode
1. Use the <MENU> button to navigate to ShNd then press <ENTER>.
2. Then use the <UP/DOWN> buttons to display CoLo then press <ENTER>.
3. Press the <UP/DOWN> buttons to display Auto.
4. Press the <ENTER> button, then from here use the <UP/DOWN> buttons to
navigate the speed setting from SP1 (slow) to SP8 (fast).
5. Press the <ENTER> button, then <ENTER> again to save.