Blizzard Lighting CSI Xtreme The Puck (Rev B) - Manual (Page 15)

Page 15
The Puck CSI Xtreme User Manual Rev. B Copyright (c) 2014 Blizzard Lighting, LLC
Fade Mode
1. Use the <MENU> button to navigate to ShNd then press <ENTER>.
2. Then use the <UP/DOWN> buttons to display FAde then press <ENTER>.
3. Press the <UP/DOWN> buttons to navigate the speed setting from SP1
(slow) to SP8 (fast).
4. Press <ENTER>. The selected fade will start in 15 seconds.
Individual Pixel Group Intensity
Allows the user to adjust the intensity level of each grouping of LEDs. These settings are
global, they will effect all modes.
1. Use the <MENU> button to navigate to NAnu, then press <ENTER>.
2. Then use the <UP/DOWN> buttons to choose either red, Gree, bLue, or
Uhlt.
3. Press the <ENTER> button.
4. Use the <UP/DOWN> buttons to select from 0 (off) to 255 (100%).
5. Press the <ENTER> button to confirm.
Troubleshooting
Symptom Solution
Fixture Auto-Shut
Off
Check the fan in the fixture. If it is stopped or moving slower than
normal, the unit may have shut itself off due to high heat. This is to
protect the fixture from overheating. Clear the fan of obstructions,
or return the unit for service.
Beam is Dim Check optical system and clean excess dust/grime. Also ensure that
the 220V/110V switch is in the correct position, if applicable.
No Light Output Check to ensure fixture is operating under correct mode, IE sound
active/auto/DMX/Etc., if applicable.
Chase Speed Too
Fast/Slow
Check to ensure proper setup of speed adjustment.
No Power Check fuse, AC cord and circuit for malfunction.
Blown Fuse Check AC cord and circuit for damage, verify that moving parts are
not restricted and that unit’s ventilation is not obstructed
Slow Movement Verify that 220V/110V switch is in the correct position, if applicable.
Also check that speed channels are set appropriately.
No Response to
Audio
Verify that the fixture is in “Sound Active” mode.
Adjust Audio Sensitivity, If Applicable.
Fixture Not
Responding /
Responding Er-
raticly
Make sure all connectors are seated properly and securely.
Use Only DMX Cables and/or check cables for defects
Install a Terminator.
Reset fixture(s).
Intermittent
Lamp
Check lamp for properly installation.
Relamp, lamp may have reached end of life.
Remote Doesn’t
Work
Verify remote control cable is installed properly and securely.
Verify remote is correct type (CA-9 or other as applicable.)
Fixture Moving
On Its Own
Verify proper mode of operation. Is the fixture in “Auto” mode?
If your problem persists or isn’t listed contact [email protected].