Blizzard Lighting RGBAW ToughPar Zoom (Rev A) - Manual (Page 13)

Page 13
ToughPAR Zoom RGBAW Manual Rev. A Copyright (c) 2013 Blizzard Lighting, LLC
Color Calibration Settings:
1.) Press the <MEnU> button, then use the <UP/DOWn> buttons until the display reads
CAL
and press
the <EnTER> button
.
2.) Press the <UP/DOWn> buttons until the display reads
RED
(Red intensity, 0-255),
GREN
(Green inten-
sity, 0-255),
BLUE
(Blue intensity, 0-255),
WHIT
(White intensity, 0-255), or
AMB
(Amber intensity, 0-255)
and adjust to your desired values.
4.) Push the <EnTER> button to confirm and save.
5.) Press the <UP/DOWn> buttons until the display reads
USE
and push the <EnTER> button. Then to
activate/deactivate these settings, select either
On
or
OFF.
6.) Push the <EnTER> button to confirm your choice.
Slave Mode:
1.) There is no need to manually set additional fixtures to slave mode. Fixtures that are linked in the DMX
chain after the first unit (master) will receive data automatically and function as the master fixture does.
LED Display On/Off:
1.) Press the <MEnU> button until the display reads
DISY
and press the <EnTER> button.
2.) Press the <UP/DOWn> buttons until the display reads either
On
or
IM
. When
On
is active, the LED dis-
play will be turned on continually. When
IM
is active, the LED display will shut off after 1 minute of inactivity.
3.) Push the <EnTER> button to confirm your choice.
Fixture Reset (Last saved values):
1.) Press the <MEnU> button until the display reads
REST
and press the <EnTER> button.
2.) Press the <UP/DOWn> buttons until the display reads
YES
.
3.) Push the <EnTER> button to confirm your choice.
Restore Factory Settings:
1.) Press the <MEnU> button until the display reads
LOAD
and press the <EnTER> button.
2.) Press the <UP/DOWn> buttons until the display reads
YES
.
3.) Push the <EnTER> button to confirm your choice.
Send Data to Other Fixtures:
1.) Link your master/slaved fixtures DMX in/out.
1.) Disconnect the DMX cable from your controller (if applicable).
1.) Press the <MEnU> button until the display reads
SEND
and press the <EnTER> button.
2.) Press the <UP/DOWn> buttons until the display reads
YES
.
3.) Push the <EnTER> button to confirm your choice.
Note: The settings of <ADDR> and <CAL> will not be sent. The slaved/receiving fixture(s) will reset auto-
matically after receiving the data correctly.