Blizzard Lighting KLIMATEKONTROL DMX Controller User Manual
Page 10
KLIMATEKONTROL Manual Rev A.
Page 10
Copyright © 2012 Blizzard Lighting, LLC.
ALL RIGHTS RESERVED
to delete.
4. All LEDs will fl ash 3 times, and the LED indicator for the selected
scene will now remain off. The scene has been deleted.
5. Repeat steps 2-4 to delete additional presets if desired.
6. Hold
<PROGRAM/REC> for 3 seconds to exit programming mode.
The LED indicator above the <PROGRAM/REC> button will extin-
guish.
3.4 Chase Programming
A chase is a sequence of different scenes or steps which are called one after
another. KLIMATEKONTROL can store up to 8 programs of 32 scenes each.
3.4.1 Creating A New Chase
1. Enter programming mode as described in Section 3.2.1.
2. Using
the
<CHASE 1-8> button, select the chase you wish to pro-
gram.
3. Using
the
<FIXTURE SELECTOR> button(s), select the fi xtures to
include in the chase step.
4. Adjust
the
fi xture(s) output using <CHANNEL FADERS 1-4> as de-
sired, OR, to use a previously programmed scene/color preset:
5. Select the desired scene bank using <UP/DOWN>.
6. Press
<SCENE 1-8>.
7. Press
<PROGRAM/REC>. All LEDs will blink 3 times to indicate the
fi rst step has been stored successfully. If no data has been stored,
the LED display will read NULL.
8. Repeat steps 2-6 to store additional steps if desired. Up to 32 steps
may be stored in each chase. If 32 steps have been stored in a chase
and the user attempts to store an additional step, the LED display will
read FULL.
9. Hold
<PROGRAM/REC> for 3 seconds to exit programming mode.
The LED indicator above the <PROGRAM/REC> button will extin-
guish.
NOTE: After scene programming, press the <DEL/CLEAR> button to clear
any output, to avoid inadvertently overwriting a scene/color preset.
3.4.2 Inserting a Chase Step
1. Enter programming mode as described in Section 3.2.1.
2. Using
the
<CHASE 1-8> button, select the chase you wish to modify.
3. Press
the
<INSERT/TAP> button. The LED indicator will illuminate
and the current step will display on the LED display. If there are no
steps in the chase, the display will read ST00.
4. Use
the
<UP/DOWN> buttons to select the position for the inserted
step.
5. Using
the
<FIXTURE SELECTOR> button(s), select the fi xtures to
include in the chase step.
6. Adjust
the
fi xture(s) output using <CHANNEL FADERS 1-4> as de-
sired, OR, to use a previously programmed scene/color preset:
7. Select the desired scene bank using <UP/DOWN>.
8. Press
<SCENE 1-8>.
9. Press
<PROGRAM/REC>. All LEDs will blink 3 times to indicate the
fi rst step has been stored successfully. If no data has been stored,