Blizzard Lighting KLIMATEKONTROL DMX Controller User Manual

Page 12

Advertising

KLIMATEKONTROL Manual Rev A.

Page 12

3. Select the desired scene/color preset using <SCENE 1-8>.

3.5.3 Chase Playback Mode

Allows the user to display one or more of up to 8 previously programmed

chases in sequence.

1. Ensure that BLACKOUT mode is not selected, IE that the LED indica-

tor above the <BLACKOUT> button is not lit.

2. Press

<CHASE 1-8> to run a chase directly. The corresponding LED

indicator will illuminate.

3. If you wish to run additional chases in sequence, select additional

chases to run by again pressing <CHASE 1-8>. The fi rst chase se-

lected will have its LED indicator lit. Subsequently selected chases

will have their LED indicators fl ash once per second.

4. Now, select the playback mode for the chase; Auto, Music or Manual.

3.5.3.1 Auto Mode

In auto mode, the chases will automatically move through their individual

steps based on the chase and fade times set using the <CHASE TIME> and

<FADE TIME> faders.

1. Follow the steps indicated in Section 3.5.3.

2. Press

the

<RUN MODE> button until the LED indicator for AUTO

mode is illuminated.

3. Using

the

<CHASE TIME> fader, adjust the time each step will be

displayed, between 0.1 and 60 seconds per step. The LED display will

indicate the current time.

4. Using

the

<FADE TIME> fader, adjust the fade time, expressed as

a percentage (0-100%) of the total chase time. The LED display will

indicate the current percentage.

5. Using

the

<UP/DOWN> buttons, adjust the number of times to loop

each chase. This function is only applicable when 2 or more chases

are being run in sequence.

6. Finally, you may override the chase/fade times set using the faders

by using the <INSERT/TAP> button. Press the <INSERT/TAP>

button and the LED indicator will begin to blink.

7. Press

the

<INSERT/TAP> button again and the LED indicator will be

extinguished. The amount of time between successive button presses

will be the new chase time.

8. Adjusting

the

<CHASE TIME> or <FADE TIME> faders will override

this setting.

3.5.3.2 Music Mode

In music mode, the chases will automatically move through their individual

steps based on the beat detected via the internal microphone.

1. Follow the steps indicated in Section 3.5.3.

2. Press

the

<RUN MODE> button until the LED indicator for MUSIC

mode is illuminated.

3. Using

the

<UP/DOWN> buttons, adjust the sound sensitivity to

achieve optimal beat detection.

3.5.3.2 Manual Mode

Advertising