Blomberg GIN 9483 ED - Manual (Page 29)

28 EN
For the steam function to be available,
you need to have sufficient amount of
salt in the dishwasher for salt filling.
If you need to open the dishwasher’s
door when the steam wash is active,
do this very slowly and take care as the
emitting steam is at high temperature.
Preparing the machine
1. Open the tap.
2. Plug in to the socket.
3. Open the door of the dishwasher.
4. Place the dishes in accordance
with the instructions in the user
manual.
5. Make sure that the upper and lower
impellers rotate freely.
6. Put adequate amount of detergent
into the detergent dispenser.
7. Check if the Salt and Rinse Aid
indicators light and add salt and/or
rinse aid if needed.
8. Close the door of the dishwasher.
Programme selection
1. Press On / Off key to turn on your
machine.
2. Refer to “Table of Programme Data
and Average Consumption Values”
to select a washing programme
suitable for your dishes.
3. Press Programme Selection key
repeatedly until the number of
the selected programme appears
on the Programme indicator .
Programme number will increase
by one each time you press the
key.
C
Number of the programmes on the
machine may change depending
on the model you have purchased.
Adding an auxiliary function
to the programme
Depending on your needs, you can
add Half Load (1/2), Tablet Detergent,
SteamPower and Time Delay
functions to the programme you have
selected.
Press the key of the function you
wish to add. Indicator of the relevant
function will appear on the display.
Setting Time Delay function
If an economical electricity tariff is
applied in your region, you can use
the Time Delay function to wash your
dishes during appropriate hours.
1. Press the Time Delay function
key after selecting the washing
programme and other auxiliary
functions. Time Delay indicator ()
will start flashing on the display.
2. Press Time Delay key to set the
time you wish. Time will increase
with increments of 30 minutes up
to 24 hours every time you press
the key.
3. Press Start / Pause / Cancel key.
Delay time will start countdown.
Time Delay indicator () and
Start / Pause indicator will light
continuously. Remaining time
will appear on the Time Delay
indicator. Programme will start
automatically when the countdown
is over.
Changing the settings during Time
Delay
While the Time Delay function is
activated, you can make changes
in the washing programme, other
auxiliary functions or the delay time.
1. Press Start / Pause / Cancel key
to switch the machine into Pause
mode. Countdown will stop.