Blomberg GIN 9483 ED - Manual (Page 31)

30 EN
a Washing Step indicator
b Rinsing Step indicator
c Drying Step indicator
d End of Programme indicator
Indicators for Washing, Rinsing and
Drying will light respectively on the
display while the selected programme
is running. Only the End of Programme
indicator lights up when the
programme is over. “00:00” appears on
Remaining Time indicator.
Canceling a programme
1. Press and hold Start / Pause /
Cancel key for 3 seconds while the
programme is running.
2. Release the key when the Start /
Pause indicator starts flashing. For
a couple of minutes the machine
will fulfill the necessary operations
required to cancel the programme.
Once the Time Delay function is
cancelled, “00:00” will appear on
the Remaining Time indicator.
C
You can select and operate a
new programme following the
cancellation of the programme.
C
There might be residues of
detergent or rinse aid left in the
machine and/or on the pieces
being washed depending on the
step the previous programme was
in at the time of such cancellation.
Changing a programme
1. Press Start / Pause / Cancel key
to switch the machine into Pause
mode.
2. Select the desired programme by
pressing the Programme Selection
key.
3. Press Start / Pause / Cancel key to
start the new programme.
C
The new programme will start from
the step where the previous one
has stopped. For example, if the
previous programme has remained
in rinsing step, the new programme
will start from the rinsing step as
well. If you want to run the newly
selected programme from the very
beginning, you have to cancel the
programme first and then select a
new programme.
Salt indicator
Check the Salt indicator on the display
to see whether there is enough
softening salt in your machine or not.
You need to refill the salt container
whenever the Salt indicator lights.
C
If the water hardness level is saved
as (r1), Salt indicator will never
come on even if the salt container
is empty. (Adjusting the water
hardness level is explained in
Water Softening System section.)
Rinse Aid indicator
Check the Rinse Aid indicator on the
display to see whether there is enough
softening rinse aid in your machine
or not. You must refill the rinse aid
container when the Rinse Aid indicator
comes on.
C
If the Rinse Aid indicator is set
to OFF, Rinse Aid indicator will
never come on even if the rinse aid
container is empty.
YM_program_
takibi
� � � �
��