Blomberg GSN 9583 XB630 - Manual (Page 33)

32 EN
except the Start / Pause / Cancel key
or by opening the door. If you do not
take any action, the audio warning will
also stop automatically after 2 minutes.
If the Extra Dry function is not
selected in the Blink and Mini 35
programmes, then the Drying step
indicator will not turn on.
Changing a programme
To change your selection after the
programme has started:
1. Press Start / Pause / Cancel key to
switch the machine in pause mode.
2. Press > or < Selection keys to
select the desired programme.
3. Start the new programme by
pressing Start / Pause / Cancel key
again.
The new programme will start from
the step where the previous one
has stopped. For example, if the
previous programme has remained
in drying step, new one will start
from the drying step as well.
If you want to run the new
programme from the very
beginning, first you must cancel the
current programme and then select
a new programme.
Canceling a programme
Press Start / Pause / Cancel key for
3 seconds to cancel the programme.
“Cancel...X” appears on display. X
denotes the time in seconds you need
to keep the key pressed.
“Finished” will appear 1 minute after
the process has started. After this, you
can set the new programme, function
or time on the machine.
There might be residues of
detergent or rinse aid left in the
machine and / or on the pieces
being washed depending on the
step the programme you have
cancelled was in.
End of programme
When the programme is over,
“Finished” will appear at the display
information line. End of programme
indicator will turn on in the programme
step follow-up indicators and 00:00 will
appear on the remaining time indicator.
1. Press On / Off key to turn off your
machine.
2. Close the tap.
3. Unplug the machine from the
socket.
Machine settings
You can use Settings Menu to change
the Language, Brightness, Contrast,
Display mode, Volume, Water
Hardness and Melody settings you
are going to use in your machine, or
Restore Factory Settings.
To enter the “Settings Menu”:
1. Press On / Off key to turn on your
machine.
2. Press Function and Time Delay
keys together for 3 seconds.