Blomberg GSN 9583 XB630 - Manual (Page 35)

34 EN
“Auto Door Open: On” appears on
the display.
5. Select “Off” with > and < Selection
keys.
6. If you see “Stored!” after pressing
the Confirmation key, Auto Door
Open function will be disabled for
all programmes. If you want to
enable this function again, set it to
“On” in step 5 above.
Display mode
“Display mode” menu contains “Eco”
and “Normal” options. If you select
“Eco”, your machine will decrease the
screen brightness automatically after
a while and save energy. If you select
“Normal”, screen brightness will not be
changed.
Volume
You may enable the machine to warn
you audibly thanks to the “Volume”
setting.
Select one of the following levels:
0- Off
1- Medium
2- High
Water Hardness
You need to adjust the “Water
Hardness” level to one of the following
values that suits the properties of your
supply system.
1- Lime free,
2- Very little limy
3- Less limy
4- Mediocre limy
5- Limy
6- Very much limy
Melody
You can adjust melody to a level
between 1 - 4.
Factory Settings?
Proceed as indicated below to cancel
all your personal settings and restore
the factory settings:
1. Press Function and Time Delay
keys together for 3 seconds to
enter the “Settings Menu”.
2. When you are in Main Menu,
press Function key repeatedly until
“Factory Settings?” appears on
display.
3. “Factory Settings” menu does not
have any submenus. Just press
Confirmation key to reset the
settings.
4. Turn off and on again your machine
with On / Off key after “Stored!”
appears on display.
When factory settings are restored,
settings will have the following values:
Language = Turkish
Brightness = 2
Contrast = 2
Auto Door Open = On
Display Mode = Normal
Volume = 1
Water Hardness = 3
Melody = 3
Warning messages
Your machine will give you some
important feedbacks while it is running.
Remove the filter and clean it under
running water. If there is remained
water in the tank, perform the