Boomba Racing Fiesta ST Transmission Cable Bracket Bushings - Manual (Page 2)

1 Remove plastic vacuum hose from rubber
adaptor on the top of valve cover (leave
rubber adaptor in place).
13
Pull the lock rings and remove the shifter
cables from the bracket.
14
Remove the transmission bracket.
15
Remove the factory shifter bushings from
the bracket.
16
Boomba Transmission Bushings ready for
installation.
17
Install the transmission bracket. Install the
top bushings first. Thread the mounting
bolts a few threads into the housing.
The bushings with thicker flange go on top
18
Install the side bushings.
The bushing with thicker flange goes to
the outside. 19
Secure bracket to the transmission.
20
Install the shifter cables to the bracket.
Connect the shifter cables to the shifter
arms.
21
Reinstall the battery tray with the ECU.
Connect the ECU connectors.
22
Install the ECU cover.
23
Install the battery. Secure the battery to
the tray with the battery holder. Connect
the battery terminals.
24
Reinstall the air supply tube, the vent line
and the air filter box. Tighten all hose
clamps and bolts. Reconnect the MAF
sensor.