Boomba Racing Evo X Mitsubishi Ralliart 75 mm Throttle Body - Manual (Page 2)

19
Repeat this process 3 (three) more times
to allow the ECU memorize new TPS
settings.
13
Reinstall the servo motor and the spur
gear. Install the throttle body cover.
14
Bolt the throttle body adaptor to the intake
manifold. Place the factory gasket
between the adaptor and the manifold.
15
Bolt the throttle body to the manifold.
Reconnect the air supply hose. Plug the
wire harness connector.
16
Reinstall the air filter.
17
Reconnect the battery terminals.
18
Turn the ignition key to “ON” position.
DO NOT START THE ENGINE.
Wait for a minimum 20 seconds and turn
the ignition key to “OFF” position. Wait for
a minimum 20 seconds.