Boomba Racing WRX Subaru 2015+ Short Throw Shift Lever - Manual (Page 2)

1 Remove plastic vacuum hose from rubber
adaptor on the top of valve cover (leave
rubber adaptor in place).
13
Spread the side panel walls apart.
Remove the shifter assembly.
14
Remove the wire harness brackets and
the neutral lock’s plunger.
15
Remove the side shift arm’s bolt and the
shifter subassembly blots.
16
Remove the side shift arm.
17
Remove the shifter subassembly cover
and the bottom halve of the pivot bushing.
18
Remove the o-ring.
19
Punch out the roll pin.
20
Remove the reverse lock. Remove shift
lever from the base.
21
Prepare Boomba Racing Short Throw
Shifter for assembly. Remove the top
snap ring and the return springs. Remove
the orientation shoulder screw. Remove
the reverse lock slide. Grease all ball
joints.
22
Insert the shifter arm into the base. Install
the pivot bushing bottom halve and
secure the shifter subassembly cover.
Install the adaptor bushing on the shifter
arm.
23
Install the reverse lock slide. Install the
orientation shoulder screw. Install return
springs and secure them with the snap
ring.
24
Secure the shifter subassembly to the
shifter base.
25
Install and secure the side shift arm.
Install the plunger lock and the wire
harness brackets.
26
Install the shifter base and secure it to the
floor.
27
Assemble the shifter cover. Install the
center console and the hand brake booth.
Install shift knob.
28
Secure shifter to the floor from the bottom.
Reconnect the shifting cables. Install the
bottom shifter cover and the heat shield.