Bowers Group M&W Test Indicator 422 Series - Manual

&RQWDFW3RLQWZLWKÝ3RVLWLRQ
7KH LQGLFDWRU LV GHVLJQHG WR SURYLGH D
WUXH UHDGLQJ ZKHQ WKH DQJOH EHWZHHQ WKH
FRQWDFWSRLQWDQGFRPSRQHQWLVƒ
$Q\ FRQILJXUDWLRQ RI DQ DQJOH RWKHU
WKDQ ƒ QHHGV WKH GLVSOD\HG YDOXH WR
EHFRUUHFWHG )RUDSRVLWLRQRIƒWKH
FRUUHFWYDOXHLV
'LVSOD\HGYDOXH[
Test Indicator 422 Series
Please carefully review these instructions to ensure proper and accurate
use of your new Test Indicator.
visit www.moore-and-wright.com Partners in Precision
TEST INDICATOR INSTRUCTIONS
This indicator is designed to provide a true reading when the
angle between the contact point and component is 12°.
Any configuration of an angle other than 12° needs the displayed
value to be corrected. For a position of 0°, the correct value is:
Maintenance
No special maintenance is required. The bearings of the indicator
must not be oiled.
Displayed value x 1.022" or 1.022mm
Contact Point with 12º Position
DL_Instructions_Test_Ind_422 28/7/08 16:00 Page 1