Bully Dog 40440 GT for Jeep Manual - Manual (Page 16)

GT
for Jeep
15
Vehicle Settings
Set Engine Size
This is automatically determined when you choose your vehicle make and year during installation of the tune. You would only need to access this option
if you do not have a stock engine displacement size.
Set Vehicle Weight
This is automatically determined when you choose your vehicle make and year during installation of the tune. You would only need to access this option
if you do not have a stock gross vehicle weight.
Select Pyro Source
Choose either factory installed or Bully Dog pyrometers.
Set Warning Levels
Set the temperature level at which the GT will provide a warning to help you protect your engine from heat damage.
It is also possible to turn each of these settings completely off. This is appropriate if the sensor for that setting is not available or if you do not wish to
have that setting monitored by the GT.
Adjust Economy Display
Change the miles per gallon shown by the GT.
This setting should be changed if the GT is showing incorrect fuel mileage. See page 14 for more information about how to do this.
Adjust Speed Display
Change the vehicle speed shown by the GT.
This setting should be changed if the GT is showing an incorrect vehicle speed. See page 13 for more information on how to do this.
Pyro 1 Temperature Level
Pyro 2 Temperature Level
Engine Coolant Temp Level
Boost Level
Turn this setting off or add a Bully Dog boost sensor if your vehicle does not
have a factory turbo boost.
Transmission Temperature
Turn this setting off or add a Bully Dog boost sensor if your vehicle does
not have a factory transmission temperature sensor.
Startup Coolant Temp Level
This option was included to ensure that the vehicle is warmed up
properly before the GT tuning options that provide additional power
are available to be used.