Stock removal, Parts description – Bully Dog 53254 Rapid Flow Induction (RFI) Cold Air Intake User Manual
Page 5
7
8
Installation Overview:
Installation is very simple, it is separated into three parts: Removing the Stock Intake,
Preparing the RFI intake for installation, and Installing the RFI intake system. The complete
installation of the RFI intake system should total about 20 minutes.
Removing the Stock Air Intake:
Follow the steps in this section for guidance on how to remove the stock air intake.
Stock intake overview diagram: The stock intake can be seen in the picture below.
Notice the important parts of the stock air intake that are noted in the diagram below. These
items are referred to throughout these instructions.
Stock Intake overview
Stock Intake Tube
Mass Air Flow sensor
CCV Recirculation
Connections
Stock Intake enclosure
Stock Removal
Silicone CCV hose and number 8 hose clamps: This hose connects the CCV breather
tube to the CCV Recirculation Connection on the Stage 2 tube. There are two CCV recircula-
tion connections.
The four small #8 clamps are used to secure both ends when installed.
Parts Description