Bully Dog 84100 Rapid Flow Exhaust System - Manual (Page 8)

7
rAPid FlOW inSTAllATiOn
rapid Flow exhaust # 84100
2. Begin the installation with the Driver Side 1
pipe by attaching it to the drivers side cata-
lytic converter. Make sure that the stock gas-
ket is in place before attaching this exhaust
piece. Use the stock hardware to secure the
tube.
3. Attach Passenger Side 1 tube making sure to
reinstall the gasket. Use the stock hardware
to secure the tube.
4. Hang the hanger A and secure passenger side
1 tube in hanger A. Do not tighten yet!
5. Attach Driver Side 2 to the end of Driver Side
1, use a clamp to secure the attachment but
do not completely tighten the clamp because
the pipe will need to be adjusted for fit. Also
attach the tube into Hanger A and loosely at-
tach in Hanger A.
Install Driver Side 1
Install Passenger Side 1
Install Driver Side 2
Hanger A
Passenger side 1
Driver side 2
Passenger side 1
Install Hanger A