Bully Dog 84010 Rapid Flow Exhaust System - Manual (Page 4)

3
rAPid FlOW inSTAllATiOn
rapid Flow exhaust # 84010
In these steps you will remove the stock
exhaust system.
Remove the Stock Tail Pipe:
1. Locate the joint just behind the muffler
that connects the tailpipe to the front sec-
tion of the exhaust. Disconnect the tailpipe
from the front section of the exhaust, and
then move to the other end of the tail pipe
to remove the tail pipe through the rear
end of the vehicle.
2. Use channel locks and a graphite lubri-
cant to remove the hangers welded to the
tail pipe from the rubber grommets that
hold them in place. Once each hanger has
been removed from those grommets the
tail pipe can easily be removed in one peace
out the rear side of the vehicle.
Disconnect Tail Pipe from Muffler
Remove the Tail Pipe
ImPoRTanT: It is illegal in all 50 states and Canada to remove the catalytic converter. Catalytic converters must be
reinstalled in accordance with Federal Law.
REmoVinG thE stoCk Exhaust systEm
Disconnect Tail Pipe from Muffler