Bully Dog 83222 Rapid Flow - Manual (Page 9)

10
rAPid FlOW inSTAllATiOn
rapid Flow exhaust # 83222
14 At this point, if you need the extra Straight Pipe, cut the Straight Pipe to the desired
length. Keep in mind that you need 3 inches of overlap when you cut the pipe. If you don’t
need the straight pipe, simply install the muffler directly into the Cross Member section. If
the straight pipe is not needed, you will have an extra straight pipe and an extra clamp left
over when you are finished.
15. Once the entire exhaust system is installed, inspect the system to ensure that no part of the exhaust is in di-
rect contact with the chassis or body; adjustments may be necessary. Having any part of the exhaust system
in direct contact with any part of the body or chassis will the cause the exhaust to rattle.
16. Return to each of the Clamps and tighten with a 9/16” wrench. Again, do not over tighten
Clamps.
9/16”
3”