Rapid flow installation – Bully Dog 82210 Rapid Flow User Manual
Page 7
Advertising
6
rAPid FlOW inSTAllATiOn
3. Install exhaust tail pipe to the adapter by aligning prewelded hangers with appropriate grommets and
placing exhaust pipe over the adapter.
4. Now install the Ceramic coated tip and tighten it with a 17mm wrench.
5. Once the entire exhaust system is installed, inspect the system to ensure that no part of the exhaust is in
direct contact with the chassis or body; adjustments may be necessary.
6. Return to each of the Clamps and tighten with a 15mm wrench. Do not over tighten the Clamps.
Note: If you are installing the exhaust on a Mega Cab refer to the instructions on page 6 to continue.
17mm
Install Exhaust Pipe
Advertising
This manual is related to the following products: