Bully Dog 82401 Rapid Flow - Manual (Page 8)

7
rAPid FlOW inSTAllATiOn
rapid Flow exhaust # 82401
5. Install the Tail Pipe Tip by sliding it into the
Front Piece Tail Pipe and hanging it from
Hanger C.
6. At this point it is time to
install the Straight Pipe(s).
You will need to measure
and cut the Straight Pipe(s)
for the final fit. Keep in
mind when you make your final cut you will
need to leave an extra 3 inches of overlap
when you cut the Straight Pipe. Do not cut
the flared end.
7. Once the entire exhaust system is in-
stalled, inspect the system to ensure that
no part of the exhaust is in direct contact
with the chassis or body; adjustments
may be necessary.
8. Return to each of the
Clamps and tighten with a
9/16” wrench. Do not over
tighten the Clamps.
Complete System Installed
9/16”
Measure Straight Pipe
Hanger A
Muffler
Clamp
Straight Pipe
3”
Install Tail Pipe Tip
Tail Pipe Tip
Hanger C
Front Piece Tail Pipe