Bully Dog 82224 Rapid Flow - Manual (Page 9)

10
rAPid FlOW inSTAllATiOn
rapid Flow exhaust # 82224
11.Snug up the Hangers to hold the system in place but do
not tighten completely as the system may need to be ad-
justed in future steps
12. At this point it is time to install the Straight Pipe. You
will need to measure and cut the Straight Pipe for the
final fit. Keep in mind on both systems when you make
your final cut you will need to leave an extra 3 inches of
overlap when you cut the Straight Pipe. Do not cut the
flared end.
13. Once the entire exhaust system is installed, inspect the
system to ensure that no part of the exhaust is in direct
contact with the chassis or body; adjustments may be
necessary.
14. Return to each of the Clamps and tighten with a 9/16”
wrench. Do not over tighten the Clamps.
Complete System Installed
Measure Straight Pipe
Hanger A
Muffler
Clamp
Straight Pipe