Bully Dog 82020 Rapid Flow - Manual (Page 7)

8
rAPid FlOW inSTAllATiOn
rapid Flow exhaust # 82020
2. Place all of the supplied Hangers into their appro-
priate locations as shown in the above diagram.
Most Hangers will serve a dual purpose, acting as
both clamps and hangers. Hanger A will serve as
the clamp between the Down Pipe and the Adapter
with Offset. Hangers B and C will act as both clamps
and hangers to hold the muffler. Hanger D will hold
the Tail Pipe Tip.
3. Bolt the Down Pipe in place using the
stock 13mm bolts. To make installing
adapter easier start first bolt only a cou-
ple of threads and then start the second
bolt.
4. Install the adapter using Hanger A as a
clamp, tighten it down enough to hold
the Adaptor in place.
5. Add the 40” Straight Pipe into the Adap-
tor and then clamp it down to hold it in
place.
Hanger B
Hanger C
Install Straight Pipe
Hanger A
Down Pipe
Straight Pipe
Install Down Pipe