Bully Dog 81550 Rapid Flow - Manual (Page 8)

7
rAPid FlOW inSTAllATiOn
rapid Flow exhaust # 81550
5. Fit the Tail Pipe Tip to the Front piece tail pipe and
secure with a clamp but do not tighten. Ensure
that the bend of the combined pieces is directly over
the axle.
10. Install the Muffler by connecting it to the Front
Piece Tail Pipe and then tightening Hanger B.
11. At this point it is time to install the Straight Pipe if
required. Keep in mind when you make your mea-
surements that you will need to leave an extra 3
inches of overlap when you cut the straight pipe.
12. Once the entire exhaust system is installed, inspect
the system to ensure that no part of the exhaust is in
direct contact with the chassis or body; adjustments
may be necessary.
13. Return to each of the Clamps and
tighten with a 9/16” wrench. Again,
do not over tighten clamps. Having
any part of the exhaust system in di-
rect contact with any part of the body or chassis will
cause the exhaust to rattle.
9/16”
Hang Front Piece Tail Pipe from Hanger C
Measure Straight Pipe
Complete System Installed
Front Piece Tail Pipe
Tail Pipe Tip
Hanger D
Measure Distance
3”