Bully Dog 81204 Rapid Flow - Manual (Page 7)

6
rAPid FlOW inSTAllATiOn
rapid Flow exhaust # 81510,81204
2. Place all of the supplied Hangers into
their appropriate locations as shown in
the above diagram.
3. Install the Down Pipe. You will use the
stock band clamp to secure the Down
Pipe to the turbo. Secure the Down Pipe
by tightening the stock band clamp with
a 7/16” deep socket.
4. Hang the Intermediate Pipe from Hanger
A and secure to the Down Pipe using one
of the supplied clamps. At this point, se-
cure the connection so that the piece will
stay, but do not tighten down until the
entire exhaust is installed.
5. Reinstall the Catalytic Converter to the
intermediate pipe.
Hang the Hangers
Turbo
Exhaust Band Clamp
Tighten Stock Band Clamp
Reinstall Catalytic Converter