Bully Dog 81223 Rapid Flow - Manual (Page 8)

9
rAPid FlOW inSTAllATiOn
rapid Flow exhaust # 81223
7. Install the Hanger Bracket and hang Hanger D. The Hanger
Bracket will be secured to the frame of the truck using an
existing hole in the frame. The hole is on the lower part of
the frame as shown and directly across from Hanger C.
8. Install Y Pipe from Hanger B. The clamp will connect onto
the upper pipe of the Y with the lower pipe directly below.
9. Install the Passenger Front Piece Tail Pipe into the lower
Y Pipe junction. Ensure that the bend is directly over the
axle. Secure the connection with a clamp.
10. Install the Passenger Tail Pipe Tip in the Passenger Front
Piece Tail Pipe and hang from Hanger C. Se-
cure with a clamp.
11. Install the Driver Front Piece Tail Pipe into
the upper Y Pipe junction. Again ensure that the bend is
directly over the axle. Secure with a clamp. Zip tie brake
lines away from exhaust to prevent excessive heat dam-
age.
12. Install the Driver Tail Pipe Tip in the Driver Front Piece Tail
Pipe and hang from Hanger E. Secure the connection with
a clamp.
13. Install the Muffler into the base of the Y Pipe. Secure with
a clamp.
9/16”
SwITCH DIRECTIONS: THE NEXT STEPS wILL BE FROM THE BACk OF THE TRUCk
Hanger Bracket Location
Hang Hanger D
Install Front Piece Tail Pipe
Install Tail Pipe Tip
Hanger D
Hanger B
Y-Pipe
Tail Pipe Tip
Hanger C
Connect Muffler to Y Pipe
Hanger B
Passenger Front Piece Tail Pipe
Driver Front Piece Tail Pipe
Muffler