Bully Dog PMT 08 Ford 6.4L Powerstroke Version 1.0.1.2 - Manual (Page 3)

PM
T V
er
sio
n U
Pda
Te
Parts Installation:
refer to the PMT installation Manual to identify the parts
described below. The installation overview provides a
quick reference installation guide for the LMM. see the
install overview below. There are three general steps
that need to take place to install the PMT on the 6.4L
Power stroke to complete the installation of the parts:
1. The first step in installing the PMT and all of the parts
is determining the mounting position for the PMT.
There are two mounting positions offered for the PMT:
add on dash Mount and Universal dash mount. see
the back PMT mounting section in this document for
reference to the add on dash Mount. refer to the PMT
instruction manual for universal dash Mount installation
instructions.
2. The second step includes running the Cradle
Cable from the PMT mounting position down
to the oBd ll block, and plugging it into the
oBd ll block. see the oBd ll diagram below to
see the location of the oBd ll port and how the
Cradle Cable plugs into the oBd ll block. For in-
depth instructions refer to the PMT installation
manual.
3. run the Power Wire down near the oBd ll port like the Cradle Cable.
Locate the accessory wires tucked under the dash behind the oBd ll port
(see oBd ll diagram). Use the snap connected to tap into the lavander
accessory wire. The label around the accessory wires will identify the
correct wire with the label: LV inG (10a).
OBDII Port
OBDII Adapter Plug
Lavender IGN (10A) wire
Cradle Cable
Power Wire
PMT & Cradle
’08 Ford 6.4L Power Stroke Installation Overview
‘08 Ford 6.4L Power Stroke OBD ll diagram
Connect power to ING (10 A) Lavender wire