Calculated Industries 4095-C Pocket Reference Guide - Manual (Page 12)

P
ocket
R
efeRence
G
uide
— 21
KEYSTROKE DISPLAY

 0.

MATL PLAStIC

   (Pipe Type) TYPE 80 PLAStIC
Pipe Size Key
When you have chosen a Pipe Material and
Type and then enter Pipe Size, the pipe data
will be displayed.
For this example we are using 3" Steel,
Schedule 80 pipe.
KEYSTROKE DISPLAY
 
ALL CLEArEd
1. Choose the Pipe Material:

MATL StEEL
2. Enter the Pipe Type:

   (Pipe Type) TYPE 80 StEEL
3. Enter the Pipe Size:

 3 INCH
4. Toggle through the Pipe data:

80 SIZE 3 INCH

(Outside Diameter) OD SIZE 3.5 INCH

(Internal Diameter) ID SIZE 2.9 INCH

(Wall Thickness) THK SIZE 0.3 INCH

(Material) MATL SIZE StEEL

(Weight per Foot) PIPE SIZE 10.2528 LB PER FEET
(cont'd)
(cont'd)
KEYSTROKE DISPLAY
 (Copper) MATL COPPEr
The last material setting displayed is
selected, and the calculator will retain your
setting even after the power has been
turned off. Once a material is selected,
you can easily toggle through the available
types (Schedules, etc.) using the Pipe Type
function (  ). Available types of pipe
are dependent upon the material setting.
Keystrokes below show the pipe types
available for Plastic (press  until PLAStIC
is shown in the display).
KEYSTROKE DISPLAY
 
0.
  MATL PLAStIC
  (Schedule 40) TYPE 40 PLAStIC
 (Schedule 80) TYPE 80 PLAStIC
 (Schedule 120) TYPE 120 PLAStIC
 (SDR 21) TYPE SD21 PLAStIC
 (SDR 26) TYPE SD26 PLAStIC

(SDR 32.5) TYPE SD32 PLAStIC
 (SDR 41) TYPE SD41 PLAStIC
You can also directly enter a Pipe Type,
e.g., Schedule 80, by entering a number
corresponding to the pipe type.