Calculated Industries 8025 - Manual (Page 23)

P
OCKET
R
EFERENCE
G
UIDE
— 19
ENTERING DIMENSIONS AND UNITS
When entering Feet-Inch dimensional val-
ues, you must enter the largest dimension
first — Feet before Inches, Inches before
fractions. To enter fractions of an Inch,
enter the numerator (value above the line),
press / (Fraction Bar key) and then enter
the denominator (value below the line).
numerator 3
fraction bar —
denominator 16
For all other units of measurement, you
can only enter whole numbers or decimal
numbers. You cannot enter combinations
of units (for example, you cannot enter 12
Meters 6 Centimeters 4 Millimeters).
USING THE
ULTRA MEASURE MASTER