Calculated Industries 6425-C - Manual (Page 44)

42 — DigiRoller
™
Plus II
Error Codes
When an error occurs, the display will show one of the following mes-
sages:
Error 1 Attempt to enter a wheel ratio of 0%
Error 2 Attempt to add values of unlike dimensions in memory
Error 3 Attempt to move a current room with 0 length, 0
width, and non-zero height into the area key
nonE Attempt to enter fixed distance or AutoCount mode
with zero (0) stored in the fixed distance key
Lo batt Low battery power
FULL Attempt to move measurement(s) into the Area
Number registers but all Area Number registers are full
OFLO Attempt to display a value too large for display
Most errors can be cleared by pressing the [RESET] key.
6425-UG-C 4/4/03 12:44 PM Page 44