Calculated Industries 6020 v2.0 - Manual (Page 4)

4 – Scale Master ® Classic
[M2x] – Memory Add key (Width)
Adds the displayed value to memory.
This key is used to store a width in
order to calculate an area. When a
length and width have been stored in
[M1+]
and [M2x], pressing [Rcl]
[M2x] displays the stored width, the
next press of [M2x] displays the area
calculated from the stored length and
width, and the next press of [M2x]
displays a calculated volume if a
height has been stored. Please see
pages 10-12 for storing and calculat-
ing an Area and Volume.
[Reset]
Used to reset display. When pressed
together with another key, clears the
value of that key.
Imperial/Metric Modes
The Scale Master Classic is set up to use
Imperial (English) dimensional units
by default. The Scale Master Classic can
be set up to use Metric scales by using
the following sequence:
1) Turn unit off via switch.
2) Press and hold [Subtract/Count] key.
3) Turn unit on via switch.
4) Release [Subtract/Count] key.
While in Metric mode, MET will remain
lit in the scale box.
Repeat the procedure above to switch
back to Imperial mode.
6020UG-EFS-C 6/27/03 2:19 PM Page 4