Calculated Industries 6020 v3.2 - Manual (Page 5)

3 – User’s Guide
[RESET]
Used to clear the display. When pressed together
with another key, clears the value of that key.
U.S. and Metric Modes
The Scale Master Classic is set up to use U.S.
scales by default. The Scale Master Classic can
be set up to use Metric scales by performing the
following steps:
1) Remove the battery door on the back of the
Scale Master Classic and remove batteries.
2) Flip the switch from IMP
(U.S. /Imperial mode)
to MET (Metric mode).
3) Replace the batteries and
battery door before using
the Scale Master Classic.
While in Metric mode,
MET will remain lit in the display.
U
sinG The
s
Cale
M
asTer
C
lassiC
Adjusting the Wheel
The Celcon® polymer wheel can be adjusted
for each user’s preference.
To adjust the wheel, take
a small, flat-head jeweler’s
screwdriver and slightly
rotate the screw located
near the wheel tip. Rotating
the screw about 1/4 to 1/3
turn should be sufficient. Rotating the screw
Rotate to Adjust Wheel
(Cont’d)
Metric
Mode
U.S.
Mode