Diode LED Mist-Resist - Manual (Page 4)

DIODELED.COM 1.877.817.6028
MIST RESIST EMBER™ LED STRIP LIGHT
WARNINGS
1. Always consult a qualified, licensed electrician prior to the installation of this product. Diode LED recommends that a
qualified, licensed electrician perform the installation of this product.
2. Always pre-test your strip light assembly by making all connections and connecting the strip to a power supply and
ensure that all components are joined properly before they are installed.
3. It is recommended that adequate airflow and heatsink be taken into account in the application and installation of this
product. Improper thermal management may lead to premature failure.
4. Exceeding the operating temperature values may damage LED chips by reducing the total lamp life and lumen output,
and inversely impact color consistency.
5. Each maximum run requires a dedicated line from the power supply to avoid voltage drop.
6. This product should only be cut at “cut points,” which are designated with a scissor icon.
7. “Voltage drop” is a gradual lessening of power through a wire over a long distance. The farther the light is from the power
source, the more voltage drop will occur. Voltage drop becomes a significant factor in any LED light application when the
distance between the lights and the power source is greater than 30 feet. Consult a licensed electrician and an online
voltage drop calculator to learn what gauge wire will work best for your configuration. For more tips, visit the Tools &
Resources section on www.DiodeLED.com.
8. The manufacturer rates each power supply for maximum power output at optimum thermal and voltage conditions. As
with any power supply, true actual maximum continuous current output depends upon various environmental factors
such as ambient temperature, line voltage fluctuations, and orientation that may affect heat dissipation. For optimum
performance, make sure the load is between 50% and 80% of the total capacity of the power supply
9. Actual color may vary from what is pictured on this sheet and other Diode LED print materials due to the limitations of
photographic processes.
10. LED products are continuously being improved upon in ever-shortening manufacturing cycles. LED color temperature
(kelvin), lumen output, and product appearance can change from order to order. Please note that variation in color
temperature (kelvin) is commonly +/- 250k and brightness (lumens) is +/- 10%.
11. Diode LED reserves the right to modify the design of our products as part of the company’s program of continuous
improvement. Diode LED cannot guarantee to match existing installed product for subsequent orders or replace the
product exactly to match the product you are replacing in product appearance, color, or brightness. Specifications are
subject to change without notice.
WARRANTY
If you have any warranty related questions please contact Diode customer service at
[email protected] or call (877) 817-6028.
Limited Warranty: This product has a five (5) year limited warranty from the date of shipment. The complete warranty
details are posted on the website at www.diodeled.com under the tools and resources tab. Specific warranty periods can
also be found on the individual published Product Specification Sheets.