Diode LED Nicolaudie STICK 1 - Manual (Page 2)

1. Mount an electrical box
inside the wall
The S.T.I.C.K. controller can be installed in any standard
electrical backbox. If you use a double size box,
you can insert the power supply inside.
2. Connect the wires
DMX: Connect the DMX cable to the lighting
receivers (Leds, Dimmers, Fixtures..)
(for XLR: 1=ground 2=dmx- 3=dmx+)
POWER: Connect a 6V DC 0.65A.
Be sure to not invert the + and the ground.
3. Mount the interface on the wall
First, mount the back side of the interface on the wall with 2 or more screws
Secondly, plug the 2 connectors (see blue arrow)
Then, close the interface, using one screw
Sunlite Touch-sensitive Intelligent Control Keypad Ref. STICK-KE1 Page 2/4
Technical datasheet Revision date 2 May 2013 www.nicolaudie.com Version 1.2
EASY INSTALLATION
PORT 1,2,3,4 : If your application
need to have some external contact
closures, make the contacts between
the ground and the ports
© Nicolaudie-Sunlite 1989-2012. All rights reserved. We reserve the right without notice to amend the technical information and specifications.