DJI Z15-5D III (HD) User Manual

Page 15

Advertising

Zenmuse Z15-5D III (HD)

User Manual

Turn to next page to obtain the
correspondence between the GCU
channels and S-Bus/PPM channels.

Battery

Connect the XT60 to the GIMBAL on center frame if S1000 used.
Attention that S1000 power supply voltage should be within the defined limits (6S), when using
one battery for both S1000 and Gimbal power supply.
Refer to S1000 User Manual for details.

ROLL

TILT

PAN

MODE

SHUT

AUX1

AUX2

AUX3

A2/WKM

•
•

•

S-Bus

PPM

2-Position Switch

3-Position Switch

2-Position Switch

3-Position Switch

2-Position Switch

USB Port

PC connection for configuration and

firmware upgrades with an USB cable.

Ensure the side with copper contacts is

facing upward towards the heat sinks.

RC Receiver

(Aircraft control)

Battery
(4S~12S)

Wireless Video

Transition Module

Air Unit/

DJI Lightbridge

RC Receiver

（JR）

8 Channels

RC Receiver

(Futaba/Hitec)

8 Channels

S-BUS Receiver

(Futaba)

PPM Receiver

A2/WooKong-M

Please refer to your A2/WooKong-M User Manual for all connection and configuration details.

Gimbal Control Unit (GCU)

1. Make sure all ports are accessible when installing your MC so as to facilitate wiring and software configuration.

2. In 3-pin ports, the pins near the nicks are the signal pins.

3. Use the 8-pin to 6-pin cable for the G6 port, and the 10-pin to 9-pin cable for the G9 port.

4. DO NOT cover the heat sinks, and keep them unobstructed at all times.

5. The IMU module is NOT waterproof or oil proof.

RC Receiver

1. The diagram on the previous page shows example connections. The aircraft signal will transmit through

the DJI Lightbridge ground system. After connecting to the Lightbridge, it is not necessary to connect with

the RC receiver.

2. Prepare 2 receivers, one for gimbal control, and the other for aircraft control. Refer to the 2-Pilots Solution

for more detail.

3. If only one receiver is used for both aircraft and gimbal control, refer to the 1-Pilot Solution for more detail.

4. Setup the Aileron, Elevator, and Rudder channels on the gimbal control TX. The command stick will control

gimbal rotation velocity. The center position is 0, and the end point is maximum velocity in both clockwise

and counter clockwise directions. (The end point is 100%)

5. Choose one 3-position switch/channel to use as the Z15-5D III (HD) Working Mode switch. (MODE)

6. Choose one 2-position switch/channel to use as the camera shutter control switch (SHUT), and another

2-position switch to use as the camera lens orientation switch in Reset Mode (AUX2).

7. Please refer to the A2/Wookong-M User Manual for aircraft control settings. Connect the receiver to the

GCU correctly.

GCU Wiring

Advertising